FAQ
Frequently Asked Questions
Procurement and quality questions, answered the way a supplier questionnaire asks them.
Common Questions
If a question below is not covered, it can be answered directly — see the contact page.
How often should a CMM be calibrated?
Interval depends on usage, environment and the shop's own quality system requirements. Many run annual reverification with interim ball-plate or ring-gauge checks between formal intervals. The recommended interval for a given machine is stated on its quotation.
What is the difference between calibration and verification?
Calibration establishes the relationship between a machine's readings and reference values with a stated uncertainty. Performance verification checks whether the machine still meets a specification, usually ISO 10360-2 or ASME B89.4.1. Most shop-floor "CMM calibration" is the latter.
What does ISO 10360-2 actually test?
Five calibrated test lengths are measured three times each in seven positions, giving 105 measurements of length measurement error, designated E0 and E150, against a stated MPE.
Do you offer CMM calibration near me?
On-site scheduling covers St. Louis and the metros listed on this site, plus the surrounding towns named on each metro's page. Machines further out are typically handled as ship-in work; the quotation states which applies before anything is booked.
What temperature does the room need to be for calibration?
ISO 1 sets 20 degrees C as the reference temperature. For acceptance testing the machine manufacturer's specified environment applies; for reverification, the environment is recorded on the certificate because it affects the result.
What happens if the machine fails as-found?
As-found deviations are recorded before adjustment. Under reverification, a length exceeding the limit on one of three repeats is re-measured three times, and all repeats must then fall within the limit.
Is the certificate accredited, and how do I check the scope?
Certificates are issued under the performing laboratory's ISO/IEC 17025 accreditation scope. The scope is published in the accrediting body's online directory and can be checked against the measurement ordered.
What is a CMC and why does it matter to my tolerances?
Calibration and measurement capability is the smallest uncertainty a laboratory can claim within its scope. If the CMC does not comfortably support the tolerance being inspected, a 4:1 test uncertainty ratio may not hold.
Will CMM calibration satisfy an IATF or AS9100 auditor?
IATF 16949 clause 7.1.5.3 and AS9100's measurement traceability requirements ask for evidence the external laboratory is ISO/IEC 17025 accredited or otherwise customer-approved. Scope documentation is provided to support that review.
What is an error map, and can it be updated on my controller?
The volumetric compensation map corrects for systematic geometric error across the measuring volume. It is updated during geometric adjustment where the controller allows access; some OEM controllers lock that access to their own service channel.

Further Detail
Standards, traceability and equipment control are set out on the quality system page. Commercial terms are in the terms and conditions.
Question about a specific item?
Send the detail and it is answered against the method that would actually be used.